Information Clean out airways/end of programme

Clean the fluff filters.

To remove the plinth filter, press the round indented area on the heat exchanger access panel to open it, see Fig. 1.

Pull the plinth filter out by the handle, see Fig. 2.

Pull the handle out of the plinth filter, see Fig. 3.

Clean the plinth filter thoroughly under running water.

Squeeze the water out of the plinth filter thoroughly.

The plinth filter must not be put back dripping wet. A fault may occur.

Use a damp cloth to remove any fluff from the handle.

Fit the plinth filter back on the handle, making sure it is the correct way round, see Fig. 3.

First insert the handle – with the plinth filter attached – over the two guide pins.

The word Miele on the handle must be the correct way up.

Push the plinth filter in completely.

The act of pushing in the plinth filter will also push in the right-hand guide pin.

Close the heat exchanger access panel.

The tumble dryer is only to be operated with the plinth filter fitted correctly and the heat exchanger access panel closed. The access panel must be closed correctly to ensure that water cannot leak from the condenser system and to ensure that the tumble dryer functions properly.

Touch the OK sensor control to confirm and clear the message.

The fault message will no longer be displayed.

Using too much detergent during washing may result in white encrustations on the edges and front of the plinth filter, see Fig. 4.

Wash the plinth filter separately in the washing machine without detergent at max. 40 °C with a spin speed of max. 600 rpm.

If the plinth filter is cleaned incorrectly or if it is very old, it may tear or deform, see Fig. 5. It will no longer fit tightly. Fluff will get into the heat exchanger unfiltered.

Replace the plinth filter.

You can order a plinth filter from the Miele online shop.